Research Paper
Abdollah Madadkar; Ahmad Kalhor; Amirreza Kosari
Volume 9, Issue 2 , September 2016, Pages 1-9
Abstract
In order to overcome the nonlinear terms in the flight equations of a launch vehicle, an appropriate control strategy has to be designed. In this paper, the fundamentals of designing a simple controller in order to control a typical launch vehicle for tracking the optimum launch vehicle path is presented. ...
Read More
In order to overcome the nonlinear terms in the flight equations of a launch vehicle, an appropriate control strategy has to be designed. In this paper, the fundamentals of designing a simple controller in order to control a typical launch vehicle for tracking the optimum launch vehicle path is presented. The principals of this strategy are based on on-line linearization of the nonlinear equations in each sampling interval during the flight and eventually representing system equations as extended Jacobean equations. It is important to note that equations linearization does not work in some areas and equilibrium points of the system but in each sampling interval is trying the system of nonlinear equations can be transformed into linear equations and then by using the pole placement theory, a good tracking controller proposed for the system. Design and simulation results show good accuracy and proper convergence of the reference signals (speed and pitch angle signals) and eventually, the success of the mission.
Research Paper
Seyed Mohammad Sadegh Mosvi; Mehdi Mortazavi
Volume 9, Issue 2 , September 2016, Pages 11-24
Abstract
In order to be sure from true function of satellite’s Attitude determination and Control Subsystem (ADCS) and its parts, some tests are needed to be done in part or subsystem level. One of the useful tools for doing these tests is Helmholtz Coil. This tool is usable in functional tests and calibration ...
Read More
In order to be sure from true function of satellite’s Attitude determination and Control Subsystem (ADCS) and its parts, some tests are needed to be done in part or subsystem level. One of the useful tools for doing these tests is Helmholtz Coil. This tool is usable in functional tests and calibration of satellite’s magnetic sensors and actuators, in Hardware In the Loop (HIL) tests of ADCS subsystem, and also in related tests to residual magnetic of satellite’s part. In this paper, we study mathematical equations of Helmholtz coil, propose design procedure and requirements, also introduce set of functional and identification tests for evaluating the constructed Helmholtz Coil. By obtaining results and finding the mathematical model of Helmholtz Coil, preparations for designing closed loop control system to eliminate environmental magnetic disturbances and create desired magnetic field by Helmholtz coil are provided.
Research Paper
Hamed Arefkhani; Mehran Mehdi-Abadi; Seyed Mohammad Mehdi Dehghan
Volume 9, Issue 2 , September 2016, Pages 25-34
Abstract
In this paper, magnetic spin control using Spin and B-dot control laws have been studied in a lab environment. Evaluation of this control laws is done by a "three degrees of freedom air-bearing simulator". Due to the inherent simulator limitations, laboratory test results are visible only on one axis. ...
Read More
In this paper, magnetic spin control using Spin and B-dot control laws have been studied in a lab environment. Evaluation of this control laws is done by a "three degrees of freedom air-bearing simulator". Due to the inherent simulator limitations, laboratory test results are visible only on one axis. Therefore, to evaluate these three-axis laws precisely, evaluation modeling is discussed by comparing the simulator dynamic and kinematic equations with the results of laboratory experiments. After evaluation of the modeling process, simulation of three-axis control law is conducted. Since the validated model shares same basis with satellite model equations except the torque disturbances caused by the distance between the center of the mass and the center of the rotation, it can be assured that these control laws are suitable for three-axis control of a satellite. Test results indicate appropriate performance of control laws.
Research Paper
Leyla Mohammadi; Shervin Amiri; Gholamreza Mohammadkhani
Volume 9, Issue 2 , September 2016, Pages 35-46
Abstract
One of the main challenges of the Open-Loop Signal Tracking method in GPS-RO space receivers, is Doppler prediction. Almost in all satellite communication systems, accurate carrier phase tracking under difficult conditions is depend on Doppler prediction accuracy. Obviously, there are several methods ...
Read More
One of the main challenges of the Open-Loop Signal Tracking method in GPS-RO space receivers, is Doppler prediction. Almost in all satellite communication systems, accurate carrier phase tracking under difficult conditions is depend on Doppler prediction accuracy. Obviously, there are several methods for producing a predicted Doppler model, and one of the earliest is Sokolovskiy. In this paper, we are analyzing the typical and operational atmospheric Doppler prediction models for the Open-Loop Signal Tracking of radio occultation, in satellite communications. A summary and comparison between these methods will be concluded in the end of this paper. finally we propose a prediction method can be used in national GPS-RO payloads for predicting atmospheric doppler based on combination of Sokolovsky and C.O. Ao methods.
Research Paper
Hamed Arefkhani; Seyed Mohammad Mehdi Dehghan; Amir Hossein Tavakoli
Volume 9, Issue 2 , September 2016, Pages 47-60
Abstract
In this paper, the three-axis magnetic attitude control using PD and LQR control laws have been studied in a lab environment. Evaluation of the magnetic attitude control with this control laws is done by a "three degrees of freedom air-bearing simulator". Developed dynamic and kinematic equations to ...
Read More
In this paper, the three-axis magnetic attitude control using PD and LQR control laws have been studied in a lab environment. Evaluation of the magnetic attitude control with this control laws is done by a "three degrees of freedom air-bearing simulator". Developed dynamic and kinematic equations to be used in actual simulator are evaluated by open loop test. Then control laws evaluated by comparing close loop simulation and laboratory test. Due to the inherent simulator limitations, magnetic attitude control only possible in the yaw axis. Laboratory test results indicate the improved and accurate performance of LQR control law for most satellite missions. Therefore by generalized LQR controller, three-axis simulation was performed for a satellite.
Research Paper
hamed Alisadesghi; Hamed Ramezani-Najafi; Hossein Reza Abbasi
Volume 9, Issue 2 , September 2016, Pages 61-76
Abstract
Base on space standards, the thermal design evaluations for satellites are performed using thermal balance tests. Regularly, the thermal model is used for the thermal balance test. This model is completely similar to the flight model of the satellite in terms of thermal characteristics. In this paper, ...
Read More
Base on space standards, the thermal design evaluations for satellites are performed using thermal balance tests. Regularly, the thermal model is used for the thermal balance test. This model is completely similar to the flight model of the satellite in terms of thermal characteristics. In this paper, the definition and implementation of thermal balance tests for Thermal model of AUTSAT Satellite is conducted. the evaluation of the TM and the procedure data Correlation of the numerical model have been focused. In order to increase the accuracy and feasibility of thermal mathematical model correlation, structural and complete models are considered for the balance test separately. In this study, the results of thermal balance test for the structural thermal model has been compared with the numerical analysis and the correlation procedure is illustrated. The results achieved by this procedure shows that all the requirements by the standard are satisfied in this level.
Research Paper
Payman Torabi; Abolghasem Naghash
Volume 9, Issue 2 , September 2016, Pages 77-83
Abstract
This paper presents a new methodology for a quick and efficient numerical determination of the condition for repeat ground tracks to be employed in an orbital optimization design methodology. This methodology employs the simplicity and reliability of the epicyclical motion condition for a repeat ground ...
Read More
This paper presents a new methodology for a quick and efficient numerical determination of the condition for repeat ground tracks to be employed in an orbital optimization design methodology. This methodology employs the simplicity and reliability of the epicyclical motion condition for a repeat ground track to find a semimajor axis for a given repetition cycle and inclination. Then the semimajor axis is re fined for application to any elliptical motion. This methodology was discovered by comparing two recent methods in addition to a new proposed method offered in this paper investigating both nonlinear algebraic and polynomial formulations of the governing repeat-ground-track condition relationship. A lesser known simplified method is used for preliminary solution refinement. The advantages and disadvantages of each approach are weighed with each method ’s reliability, performance, and computational ease based on a case study. From these criteria, one method is recommended for use in repeat-ground-track orbit design optimization methodology.
Research Paper
Malihe Hashemi; Seyed Kamaleddin Mosavi Mashhadi; Seyed Majid Esmaeilzadeh; Mohammad Fiuzy
Volume 9, Issue 2 , September 2016, Pages 85-90
Abstract
Attitude Determining is one of the major and critical satellites space missions. In this study, a new method to Attitude determination of satellites is presented. Such that, based on the proposed method search space will be more limited then accuracy and speed of attitude determination in the proposed ...
Read More
Attitude Determining is one of the major and critical satellites space missions. In this study, a new method to Attitude determination of satellites is presented. Such that, based on the proposed method search space will be more limited then accuracy and speed of attitude determination in the proposed method has risen. At first in this method, implementation and the test algorithms will be discussed, after these some algorithms, such as navigation, pattern recognition and ultimately attitude determination will be reviewed. In order to implement these algorithm. High quality images of stars which must provided by the star tracker camera requires to implement. Really these images to perform the necessary processing sent to the processor so the processor based on designed algorithms, determines the attitude of camera and satellite in all three axes. This means that some features considered for star tracker and based on them begins the designing process. The range of accurately determination for star tracker is one of these features. In this article, the ranges of two axes of Yao and Pitch less than 20 seconds on the scale of degree are considered and in the roll axis less than 100 seconds is intended. Can show in the results, much better accuracy and less than initial assumptions have been achieved. It also carried out by an adaptive identified algorithm so that the brighter stars are identified and based on their attitude determination, the sensor accuracy have increased. Because of according research, the clearer stars, have more accurate in calculation. The other important feature is the speed of attitude detection which performed by 1 GHz processor, and correct identification of pyramidal algorithm where have reached less than 15 milliseconds. Due to the duration, the desire update rate gained. Other important parameters which influence the accuracy of the attitude determination is knowing the exact coordinates of the intersection point vector of focal length lens with image sensors. By Land calibration for camera with a good accuracy, these parameters were estimated.
