Study of Modeling Parameters in Determination of TID, DD, and SEE Radiation Damages for Satellite in LEO Orbit Using OMERE Software

Daneshvar, Hamideh; Khoshsima, Masoud; Dayyani, Abolfazl

doi:10.30699/jsst.2019.1158

Document Type : Research Paper

Authors

¹ ِDosimetry, a Radiation Application Research School, Nuclear Science &amp; Technology Research Institute, Atomic Energy Agency of Iran, Tehran, Iran.

² Satellite Systems Research Institute, Space Research Institute, Tehran, Iran

³ satellite systems research institute, iranian space research center, Tehran, Iran

https://doi.org/10.30699/jsst.2019.1158

Abstract

One of the important issues to be considered in the design of space systems is the attention to the difference between the terrestrial and space environment. This issue changes the design and affects all subsystems of space systems. Radiation damage due to space radiation can cause disturbances in the functioning of space systems. In this paper, with a computational approach examines the most important radiation damage involving TID, DD and SEU in two satellites that have missions in LEO orbit. The calculations were performed using the OMERE software and finally, a comparison was made between different models for achieving different types of radiation damage.

Keywords

Main Subjects

investigating space radiation

References

[1] Gingrich, D., Ionizing Radiation Effects in EPF10K50E and XC2S150 Programmable Logic Devices,” Centre for Subatomic Research. Canada, University of Alberta Edmonton, 2002.

[2] Barth, J.L., “Applying Computer Simulation Tools to Radiation Effects Problems, Section II: Modeling Space Radiation Environments,” 1997 IEEE Nuclear and Space Radiation Effects Conference Short Course, July 21, 1997.

[3] Gussenhoven, M., “Improved understanding of the Earth's radiation belts from the CRRES satellite, Vol. 43, No. 2, 1996, pp. 353-368.

[4] SEECA, Single Event Effect Criticality Analysis, Sponsored by NASA Headquarters/ Code QW, February 15 1996.

[5] Sawyer, D. M., “AP8 trapped proton environment for solar maximum and solar minimum1976..

[6]T. CNE/OME/42/AV/031213 ,“ADVANCED MANUAL OMERE,” 2014.

[7] Mebrahtu, H. T., "Heavy Ion Radiation Effects on CMOS Image Sensors," Proceedings of the SPIE, Vol. 5578, 2005 (2004), pp. 323-333.

[8] Pease, R.L., “Radiation Testing of Semiconductor Devices for Space Electronics," Vol. 76, No. 11, 1988.

[9] Estandrd “Methods for the Calculation of Radiation Received and its Effects and A Policy for Design Margins SpaceEnvironment,, ECSS-E-ST-10-04C, 2008.

[11] Pickel, “Cosmic Ray Induced Errors in MOS Memory Cells,” IEEE Trans1978.

[12] Pickel, “Cosmic Ray Induced Errors in MOS Devices,” IEEE Trans1980.

[13]Available: http://www.trad.fr/en/space/omere-sotftware/.

[14] Varotsou, A., “OMERE Space Radiation Environment and Effects Tool: New Developments and New Interface.,” 2017.

[15] Varotsou, A., “The OMERE freeware for space”.

Space Science and Technology

Study of Modeling Parameters in Determination of TID, DD, and SEE Radiation Damages for Satellite in LEO Orbit Using OMERE Software

References

References

Volume 12, Issue 3 - Serial Number 40
September 2019
Pages 63-71

Study of Modeling Parameters in Determination of TID, DD, and SEE Radiation Damages for Satellite in LEO Orbit Using OMERE Software

References

References

Volume 12, Issue 3 - Serial Number 40September 2019Pages 63-71

Volume 12, Issue 3 - Serial Number 40
September 2019
Pages 63-71