Authors

Abstract

In this paper, the complete block diagram of the imaging payload of a spin satellite capable of real time imaging is designed. Because of the satellite spin, the system needs to recognize the suitable camera angle in order to start imaging. The angle is the starting point of the observation of the part of the earth to be imaged. In this paper, at first the suitable imaging method and detector for this kind of satellite are elected and then the angle and the time of the spin camera imaging and the necessary number of lines and pixels are calculated. If the system is also capable of real time imaging, the captured images should be transmitted to the earth station before the next imaging starts. The completion of the above scenario needs a complete and parallel relationship between the satellite image payload subsystem and other subsystems such as power, communication and specially satellite on-board computer. For imaging and transmission, image payload status information such as temperature, voltage and current should be sampled and transmitted to the on-board computer for processing. Also this information should be attached to the image frames and transmitted to the earth station. All this processing is summarized into time pulses with exact timing between subsystems. Because of resource limitation in a space mission, satellite systems design must have the minimum mass, power and cost. But these shouldn’t cause the efficiency and specially system processing speed to decline. Imaging payload with real time capability needs a high processing speed requiring high resource utilization. In this paper, an imaging system is designed with the mentioned characteristics based on FPGA high parallel processing speed but having low mass, volume and power.

Keywords

  1. Benhouzid, A. B., Rachedi, A. and Laidi, K., “A New Micro-Satellite CCD Camera Controller Design,” Proceedings of 2nd International Conference on Recent Advances in Space Technologies, pp. 248-253, 2005.
  2. Wertz, J. R. and Larson, W. J., Editors, Space Mission Analysis and Design, 3rd Edition, Microcosm Press, El Segundo, California, 1999.
  3. Nieke, J., Schwarzer, H., Neumann, A. and Zimmermann, G., “Imaging Space borne and Airborne Sensor Systems in the Beginning of the Next Century,” The European Symposium on Aerospace Remote Sensing (IEEE), 1997, pp. 22-26.
  4. Elachi, Ch. and Van Zyl, J., Introduction to the Physics and Techniques of Remote Sensing, 2nd Edition, John Wiley and Sons, 2006.
  5. Rees, W. , Physical Principles of Remote Sensing, Cambrige University Press, 2001.
  6. Sanchez, J. and Canton, M. P., Space Image Processing, CRC Press LLC, 1999.
  7. Mattos, P. G., “The Transputer in Satellite Signal Processing,” IEEE Colloquium on Transputer and Signal Processing,
  8. [8] Kramer, H. J., Observation of the Earth and its Environment, 4th Edition, Springer, 2002.
  9. [9] Corba, M. and Quadrini, M., “In-Flight Reconfigurable Electronics for Integral Imager Prototype,” IEEE, 1994, pp. 790-794.
  10. Stephens, P. and et al., “Launch of International Disaster Monitoring Constellation: the Development of a Novel International Partnership in Space,” RAST 2003, Istanbul, Turkey, 2003.
  11. Hadj-Sahraoui Rachedi, A. and Brewer, A. N., “Alsat-1: First Result of Multispectral Imager,” International Archives of Photogrammetry Remote Sensing and Spatial Information Sciences, Vol. 3, pp. 337-341, July 2004.
  12. Portell I De Mora, J., Payload Data Handling, Telemetry and Data Compression Systems for Gaia, PhD. Thesis, Department de Fisica Aplicada, Universitat Politecnica de Catalunya, Barcelona, June 2005.
  13. Holst, G. C., CCD Arrays, Cameras, and Displays, SPIE Optical Engineering Press, 1998.
  14. Holst, G. C., Testing and Evaluation of Infrared Imaging Systems, SPIE Optical Engineering Press,