Space subsystems design: (navigation, control, structure and…)
Moslem Karim Abadeh; Morteza Tayefi
Articles in Press, Accepted Manuscript, Available Online from 09 April 2024
Abstract
In this study, the control of a space capsule during the re-entry phase is examined. Re-entry is one of the most important phases of a spacecraft's mission because when the spacecraft enters the Earth's atmosphere, aerodynamic forces and moments will disturb the angles of attack and side slip. These ...
Read More
In this study, the control of a space capsule during the re-entry phase is examined. Re-entry is one of the most important phases of a spacecraft's mission because when the spacecraft enters the Earth's atmosphere, aerodynamic forces and moments will disturb the angles of attack and side slip. These disturb angles, if not controlled, can cause serious injuries to the spacecraft and its passengers. To eliminate the disturbances, moving mass controllers have been used as an operator. Moving mass controllers (MMC) control the flying device by creating an internal force. The main advantage of moving mass controllers compared to other operators such as aerodynamic surfaces and thrust jets is the non-production of turbulent aerodynamic force (which can disrupt the controller's performance) due to the creation of internal force. Another important factor is the mechanism of moving mass controllers. In this research, in addition to the cross mechanism, which is a more common mechanism, the radial mechanism has also been examined. A non-linear controller is needed in order to use the radial mechanism, and in this research, a non-linear proportional-integral-derivative controller is suggested.
E Peighani-Asl; D Abbasi-Moghadam; B Ghafary; V Tabataba-Vakili
Volume 2, Issue 3 , December 2009, , Pages 57-70
Abstract
Remote sensing using small spacecraft arising from multi-objective economic activity problems is getting more and more developed. These satellites require very accurate pointing to specific locations of interest, with high reliability and small latency. The space borne imaging systems always attempted ...
Read More
Remote sensing using small spacecraft arising from multi-objective economic activity problems is getting more and more developed. These satellites require very accurate pointing to specific locations of interest, with high reliability and small latency. The space borne imaging systems always attempted to achieve the highest ground resolution possible with the available technology at the given time. Also mass, volume and power consumption of the spacecrafts and instruments followed the trend to miniaturization. But the most promising prospects for high resolution imaging with remote sensing satellites are connected with passive optical systems, especially push broom systems. In this paper optical system design process is described and different parameters of this process such as MTF, SNR, FOV, aperture diameter, stability and pointing, scanning schemes, detector selection, and target radiance are simulated and analyzed.
