Document Type : Research Paper

Authors

1 Astronautical Systems Research Institute, Aerosapce Sceince and Technology, Ministry of Science, Research and Technology, Tehrant Iran

2 Aerospace Law, Management and Standards Research Institute, Aerospace Research Institute, Ministry of Science, Research and Technology, Tehran, Iran

Abstract

Antennas, which are usually installed on the outer shell of these systems, are therefore always exposed to the thermal fluctuations of the space environment. Thermal fluctuations cause the antenna surfaces to expand, contract and distort and can cause the antenna to malfunction. In this paper, the effects of thermal expansion and contraction due to an LEO orbital mission on the radial characteristics of two X-band reflective antennas, one broadband antenna and the other narrowband, And the resulting radiation characteristics are compared with the characteristics of equivalent sample antennas at ambient temperature. Analyses show that narrowband antennas are very vulnerable to thermal fluctuations and, therefore, it is necessary to choose the material of the antennas from materials whose thermal expansion coefficient is very small. In addition, choosing the appropriate protection method to maintain the optimal performance of the antenna is one of the most essential activities in the construction of space antennas.

Keywords

Main Subjects

[1] E. M. Silverman, “Space environmental effects on spacecraft: LEO materials selection guide, part 1, NASA Contractor Report 4661.Part 1,” National Aeronautics and Space Administration Langley Research Center. Hampton, Virginia, 1995.
[2] D. Angirasa, and P. S. Ayyaswamy, “Review of evaluation methodologies for satellite exterior materials in low earth orbit,” Journal of Spacecraft and Rockets, Vol. 51, no. 3, pp.750-761, 2014.
[3] S. Shrestha, C. Borrerodel Pino, and U. Malayoglu, “Inorganic White Thermal-Control Coatings for Extreme Space Environments,” Journal of Spacecraft and Rockets, Vol. 53, No. 6, pp. 1061-1067, 2016.
[4] M. Moser, C. Ranzenberger, and S. Duzellier, “Space environmental testing of novel candidate materials for multilayer insulation,” Journal of Spacecraft and Rockets, Vol. 53, No. 6, pp. 1134-1140, 2016.
[5] K. L. Bedingfield, R.D. Leach, M.B. Alexander, Spacecraft system failures and anomalies attributed to the natural space environment, NASA Reference Publication 1390, National Aeronautics and Space Administration, 1996.
[6] B. Yanqiang, J. Wang, D. Qie, S. Yonghong, and X. Li, “Experimental Study on Thermal Vacuum Environment Sensitivity of Spacecraft Antenna's Typical Failure,” MATEC Web of Conferences, Vol. 114, 2017.
[7] S. Kobayashi, T. Shimpo, & K. Goto, “Microscopic damage behavior in carbon fiber reinforced plastic laminates for a high accuracy antenna in a satellite under cyclic thermal loading,” Advanced Composite Materials, Vol.28, No. 3, pp.259-269, 2019.
[8] W. A. Imbriale, S. Gao, and L. Boccia, Space antenna handbook, John Wiley & Sons, 2012.
[9] S. Kalra, B. S. Munjal, V. R. Singh, M. Mahajan, and B. Bhattacharya., “Investigations on the suitability of PEEK material under space environment conditions and its application in a parabolic space antenna,” Advances in Space Research, Vol. 63, No. 12, pp. 4039-4045, 2019
[10] C. A. Ginty, and N. M. Endres, “Composite space antenna structures: properties and environmental effects,” NASA Technical Memorandum 88859, 18th International SAMPE Technical Conference Seattle, Washington, October 7-9, 1986.
[11] T. Y. PARK, et al, “Thermal Design and Analysis of Unfurlable CFRP Skin-Based Parabolic Reflector for Space borne SAR Antenna,” International Journal of Aeronautical and Space Sciences, Vol. 22, No. 2, pp.433-444, 2021. ‏
[12] F. Asdaghpour, “The Effects of the Space Eenvironment on The Antennas in LEO Stellites,” M. Sc. Thesis, Aerospace Research Institute, Jan. 2020.
[13] A. Mubdir, J. Al-Hindawi, “Modeling of Surface Temperature Distribution and Thermal Effects on Reflector Antenna Radiation Characteristics,” Journal of Modeling and Simulation of Antennas and Propagation, Vol. 2, No.1, pp. 22-33, 2016.
[14] Secretariat, E. C. S. S. Space environment. ECSS-E-10-04A, ESA Publications Division [Internet], 2000. Available from: www.spacewx. com/Docs/ECSS-EST-10-04C_15, Nov , 2008.
[15] jaxa.jp/pr/brochure/pdf/04/sat25.pdf
[16] W.D. Callister, and D.G. Rethwisch, Materials science and engineering: an introduction, (Vol. 7, pp. 665-715), New York. John Wiley & Sons, 2007.
[17] ASM Aerospace Specification Metals Inc, Pompano Beach, Florida 33069.
[18] R.D. Cottle, X. Chen, R.K. Jain, Z. Eliezer, L. Rabenberg, and M.E. Fine, “Designing low-thermal-expansivity, high-conductivity alloys in the Cu-Fe-Ni ternary system,” JOM, Vol. 50, No.6, pp.67-69,1998.
 [19] Y. Wang, “Multiphysics analysis of lightning strike damage in laminated carbon/glass fiber reinforced polymer matrix composite materials: A review of problem formulation and computational modeling,” Composites Part A: Applied Science and Manufacturing, 101, pp.543-553, 2017.
[20] J. D. Kraus, Antennas, 3rd Ed., New York. McGraw-Hill, 2000.
[21] R. Orr, V. Fusco, D. Zelenchuk, G. Goussetis, E. Saenz, M. Simeoni, and L. Salghetti Drioli, “Circular Polarization Frequency Selective Surface Operating in Ku and Ka Band,” IEEE Transactions on Antennas and Propagation, Vol. 63, No. 12, pp. 5929-5934, Dec. 2015.
[22] Y. R. Ding, Y. J. Cheng, “Ku/Ka Dual-Band Dual-Polarized Shared-Aperture Beam-Scanning Antenna Array with High Isolatio,” IEEE Transactions on Antennas and Propagation, Vol. 67, No. 4, pp. 2413-2422, April 2019.
[23] R. Deng, S. Xu, F. Yang, M. Li, “An FSS-Backed Ku/Ka Quad-Band Reflectarray Antenna for Satellite Communications,” IEEE Transactions on Antennas and Propagation, Vol. 66, No. 8, pp. 4353-4358, August 2018.